ESF005-1 ESF005-3 3.0kw Goose Feather Filling Machine Grey Color
Description: Feather filling machine
The machine used for sofa feather filling.
1. Make sure the equipments are in the appropriate position
according to the product line collocation.
2. Rectify the adjustable foot screw of the machine to raise the
equipment in aclinic and tie up screw cap;use inflated bolt to fast
C Inspect every pipe connections is ok, and make sure there is no
cotton or air leak.
D Inspect 3 zigzag turnplates and ducts-feeding cylinder are
well-installed, screw whether become flexible.
E Connect the Carding machine and Mixing Container electric control
box into 380V power respectively. Note the direction of motor the same with the mark of the arrowhead
on the machine, otherwise the machine will wall up by cotton and caused cease.
F Connect the power supply of the Cushion filling machine into the
electric control box of the Mixing Container.
G Open electronic box, push the air pressure button,close the
electronic box's door.
H Be sure the machine is kept on good connection with the ground.
( Note the direction of motor the same with the mark of the arrowhead
on the machine)
a Push the green knob switch on the power supply box,,motor begin
to run,and air pressure produced the machine( Note the direction of motor the same with the mark of the arrowhead
on the machine)
b Fiber feeding: put the fiber on the conveyer belt averagely. Do
not put too thick to prevent the jam in the roller.(If used with
ESF005-1 or ESF005-3,there is no necessary to fill by hand)
c Filling: Take the pillow or sofa cover into the filling exit,
press the foot valve by foot and belt feeding will begin, then the
fiber will be filled into pillow or sofa cushion.
f After the fiber filling into pillow or cushion is full stop off
the foot valve
- Clean the fiber between the rollers and exit and the valve of
- Adding the lubricant to pneumatic component of oil and mist each
- Do not keep fiber accumulated in the fan of the motor bottom .Keep
Keep the machine and working environment clean and dry.
GUIDELINE ON SAFETY MATTERS
It is dangerous to put hands into the ducts-feeding cylinder when
b When operation, don't open the cover of the machine and never put
your hands, heads or any part of body into the inside of the
machine, such as the ducts-feeding cylinder schematic diagram.
C If there is any abnormity press the urgent knob on the power
supply or the urgent knob on the right of the machine.
After completing of the work, please cut off the power supply and
the air supply.
Guideline on prodution:
A When ducts feeding, feed it evenly, adhere to the principle of
less ones, more feeding times.
B If necessary card the materials again.
C The foams are limited within above-mentioned materials.
D Please make sure no rest ducts within the valve and the shell
left in the machine before cut off the power
E If ducts jam into the machine ,please stop and tidy the machine .
F If over loading make it stop ,please wait a minute. When the over
loading protecter reposition or reposition the protecter by hand
Packaging & Delivery
7-15 working days after payment